Printer Sharp AL-1551 CS Refill Instructions

Kit          5

Gram      220

Tools     flat head screwdriver, Phillips screwdriver

1.      Using Phillips screwdriver, remove the three screws which hold the endcap in place.

2.      Gently disengage the locking tab by pulling the endcap out and to the right. When the locking tab disengages, continue this pulling motion until the endcap has been removed from the cartridge.

3.      Using flat head screwdriver, pry out plug.

4.     

Turn the sealed bottle of toner upside down.
Tap the funnel cap.
Turn the Sharp AL-1551 CS cartridge right-side-up and tap the bottom of the bottle against a counter top.

Then, tilt the printer cartridge at an angle to gain access to the filling hole created as suggested by the diagram.

You can now safely insert the funnel cap into the filling hole and start pouring toner into the laser Sharp printer cartridge.
In case toner does not flow easily into the cartridge repeat from the beginning.

If you believe your cartridge may have been reused a lot or there is some sort of premature cartridge failure you should only fill your cartridge from 1/3 to 1/2 of its capacity at most.

Now seal the filling hole with duct tape.

Finally, gently shake the cartridge from side to side

5.      Gently reattach the end cap, making sure that all of the “pins” & corresponding “posts” line up and rest flush against the cartridge body.

6. Use Phillips screwdriver to replace the screws.

The laser printer Sharp AL-1551 CS has the sharp-al-100td cartridges.