Printer Lexmark Optra T614nl Refill Instructions
Tools flat head screwdriver, cartridge hole making tool
1. Using flat head screwdriver, remove a piece of the cartridge label (see diagram).
- Turn the sealed bottle of toner upside down.
Tap the funnel cap.
Turn the Lexmark Optra T614nl cartridge right-side-up and tap the bottom of the bottle against a counter top.
Then, tilt the printer cartridge at an angle to gain access to the filling hole created as suggested by the diagram.
You can now safely insert the funnel cap into the filling hole and start pouring toner into the laser Lexmark printer cartridge.
In case toner does not flow easily into the cartridge repeat from the beginning.
If you believe your cartridge may have been reused a lot or there is some sort of premature cartridge failure you should only fill your cartridge from 1/3 to 1/2 of its capacity at most.
Now seal the filling hole with duct tape.
Finally, gently shake the cartridge from side to side
3. Tilt cartridge upward and make hole (see diagram). Note: Whether you have the 7,500 or 17,600 yield, do not insert more than 1/3 bottle of toner into this cartridge, as the cartridge will not work AT ALL until you extract some of the toner from the cartridge.
The laser printer Lexmark Optra T614nl has the lexmark-12a5740 lexmark-12a5745 lexmark-12a5840 lexmark-12a5845 lexmark-12a5849 cartridges.