Printer Lexmark 4037 Model 5E Refill Instructions

Kit          3

Gram      120

Tools     cartridge hole making tool

1.     

Turn the sealed bottle of toner upside down.
Tap the funnel cap.
Turn the Lexmark 4037 Model 5E cartridge right-side-up and tap the bottom of the bottle against a counter top.

Then, tilt the printer cartridge at an angle to gain access to the filling hole created as suggested by the diagram.

You can now safely insert the funnel cap into the filling hole and start pouring toner into the laser Lexmark printer cartridge.
In case toner does not flow easily into the cartridge repeat from the beginning.

If you believe your cartridge may have been reused a lot or there is some sort of premature cartridge failure you should only fill your cartridge from 1/3 to 1/2 of its capacity at most.

Now seal the filling hole with duct tape.

Finally, gently shake the cartridge from side to side

2.      Tilt cartridge upward and make hole (see diagram). Note: Whether you have the 7,500 or 17,600 yield, do not insert more than 1/3 bottle of toner into this cartridge, as the cartridge will not work AT ALL until you extract some of the toner from the cartridge.

The laser printer Lexmark 4037 Model 5E has the lexmark-1382760 cartridges.