LEXMARK 12A5849

LEXMARK 12A5849 Refill Instructions

Kit          3

Gram      250

Tools     flat head screwdriver, cartridge hole making tool, Replacement Chip Needed

 

1.      Using flat head screwdriver, remove a piece of the cartridge label (see diagram).

2.     

    Turn the sealed bottle of toner upside down.
    Tap the funnel cap.
    Turn the 12A5849 cartridge right-side-up and tap the bottom of the bottle against a counter top.

    Then, tilt the LEXMARK printer cartridge at an angle to gain access to the filling hole created as suggested by the diagram.

    You can now safely insert the funnel cap into the filling hole and start pouring toner into the printer cartridge.
    In case toner does not flow easily into the cartridge repeat from the beginning.

    If you believe your cartridge may have been reused a lot or there is some sort of premature cartridge failure you should only fill your cartridge from 1/3 to 1/2 of its capacity at most.

    Now seal the filling hole with duct tape.

    Finally, gently shake the cartridge from side to side

3.      Tilt cartridge upward and make hole (see diagram). Note: Whether you have the 7,500 or 17,600 yield, do not insert more than 1/3 bottle of toner into this cartridge, as the cartridge will not work AT ALL until you extract some of the toner from the cartridge.

 

Please note that the electronic “smart chip” on the outside of this cartridge reports the toner level to the machine (via radio frequency transmission). This chip will need to be replaced before the cartridge may be reused.

 

To replace the chip :

Using a flat head screwdriver, pry out old chip.

Push the new chip into place. Note : The replacement chip is backed with an adhesive to prevent it from falling out of place.

 
This cartridge may also be known as 12 A5849 or 12-A5849 or 12A5849 or lexmark-12a5849 .

The LEXMARK 12A5849 cartridge refill procedure can also be following for refilling the following printers:

  • Lexmark 4069 Optra T
  • Lexmark Optra T610
  • Lexmark Optra T610n
  • Lexmark Optra T612
  • Lexmark Optra T612n
  • Lexmark Optra T612s
  • Lexmark Optra T614
  • Lexmark Optra T614n
  • Lexmark Optra T614nl
  • Lexmark Optra T616
  • Lexmark Optra T616n
  • Lexmark OptraIMAGE 614s
  • Lexmark OptraIMAGE T610sx
  • UniSys UDS-15
  • UniSys UDS-20
  • UniSys UDS-25
  • UniSys UDS-35
  • A list of refill products for this cartridge appears below:

  • Chips chips for LEXMARK 12A5849, lowest price found 12.99
  • Refill Accessories tools for LEXMARK 12A5849, lowest price found 6.99
  • Refill Kits toner for LEXMARK 12A5849, lowest price found 29.95
  • Cartridge Components drum for LEXMARK 12A5849, lowest price found 10.99
  • Cartridge Components wiperblade for LEXMARK 12A5849, lowest price found 3.99
  • This entry was posted in Lexmark Toner Refill Instructions and tagged . Bookmark the permalink.

    Leave a Reply