HP C8061X Refill Instructions

Kit          1

Gram      500

Tools     cartridge hole making tool , Replacement Chip Needed

Please note that the electronic “smart chip” on the outside of this cartridge reports the toner level to the machine (via radio frequency transmission). This chip will need to be replaced before the cartridge may be reused.

To replace the chip :

1.      Using a flat head screwdriver, pry out old chip.

2.      Push the new chip into place. Note : The replacement chip is backed with an adhesive to prevent it from falling out of place.

Refill Instructions :

1.     

Turn the sealed bottle of toner upside down.
Tap the funnel cap.
Turn the C8061X cartridge right-side-up and tap the bottom of the bottle against a counter top.

Then, tilt the HP printer cartridge at an angle to gain access to the filling hole created as suggested by the diagram.

You can now safely insert the funnel cap into the filling hole and start pouring toner into the printer cartridge.
In case toner does not flow easily into the cartridge repeat from the beginning.

If you believe your cartridge may have been reused a lot or there is some sort of premature cartridge failure you should only fill your cartridge from 1/3 to 1/2 of its capacity at most.

Now seal the filling hole with duct tape.

Finally, gently shake the cartridge from side to side

2.      Make hole (see diagram).

 
This cartridge may also be known as C 8061X or C-8061X or C8061X or hp-c8061x .

The HP C8061X cartridge refill procedure can also be following for refilling the following printers:

A list of refill products for this cartridge appears below:

HP C8061X Refill Instructions

Kit                   1

Gram           500

Tools         cartridge hole making tool , Replacement Chip Needed

Please note that the electronic  “smart chip ” on the outside of this cartridge reports the toner level to the machine (via radio frequency transmission). This chip will need to be replaced before the cartridge may be reused.

To replace the chip :

Using a flat head screwdriver, pry out old chip.

Push the new chip into place. Note : The replacement chip is backed with an adhesive to prevent it from falling out of place.

Refill Instructions :

1.          

Turn the sealed bottle of toner upside down.
Tap the funnel cap.
Turn the C8061X cartridge right-side-up and tap the bottom of the bottle against a counter top.

Then, tilt the HP printer cartridge at an angle to gain access to the filling hole created as suggested by the diagram.

You can now safely insert the funnel cap into the filling hole and start pouring toner into the printer cartridge.
In case toner does not flow easily into the cartridge repeat from the beginning.

If you believe your cartridge may have been reused a lot or there is some sort of premature cartridge failure you should only fill your cartridge from 1/3 to 1/2 of its capacity at most.

Now seal the filling hole with duct tape.

Finally, gently shake the cartridge from side to side

2.           Make hole (see diagram).

This cartridge may also be known as C 8061X or C-8061X or C8061X or hp-c8061x .

The HP C8061X cartridge refill procedure can also be following for refilling the following printers:

A list of refill products for this cartridge appears below: